Component record · Escapement
Escape Cock
Partially verifiedThe cock or bridge carrying the upper pivot of the escape wheel.
What it does
Holds the escape wheel upright and at the right height for its teeth to meet the pallet stones correctly.
How it works
The escape wheel turns fastest in the going train and its pivots are very fine, so its bearings are jewelled in almost all lever watches. The cock locates the upper jewel exactly over the lower one in the main plate.
Because the escape-wheel teeth must meet the pallet stones at the correct height, a cock that sits high or tilted changes the contact on the stones. After fitting, the wheel should have slight end-shake and spin freely.
When the escape wheel is carried by a separate cock, it can often be removed without disturbing the rest of the train, which is convenient when adjusting the escapement.
Evolution
Separate escape cocks are common in older bridge calibres; many later movements carry the escape wheel in the train bridge.
Known variations
- Separate escape cock
- Escape bearing in the train bridge
- Combined escapement bridge
Identification for collectors
- A small one-jewel cock beside the pallet cock, over the escape wheel
Common failure modes
- Damaged jewel or bent escape pivot
- Cock not seated, changing escapement depth
Photographs



Photographs are illustrative examples of the type, not necessarily the exact object described. Verify details against the source file page.
Sources & references
- de Carle, D., Practical Watch Repairing
- de Carle, D., Watch and Clock Encyclopedia
- Fried, H. B., The Watch Repairer's Manual
- Daniels, G., Watchmaking
Where sources disagree, the disagreement is stated rather than resolved silently.