Glossary · Mechanism
Butting
An escape tooth landing on the pallet's impulse face instead of the locking face.
Explanation
Butting is an escapement fault in which an escape-wheel tooth meets the impulse face, or the corner of a pallet stone, instead of dropping onto the locking face. The tooth pushes against the stone's face and the escapement stalls or works erratically rather than locking cleanly.
It usually comes from an escapement set too shallow, pallet stones set at the wrong depth, a bent or worn tooth, or excessive shake in the pallet or escape-wheel pivots. Similar contact between the fork horn and the impulse pin is also described as butting. The remedy is to restore correct depths and pivot fit, not to lubricate the escapement more heavily.
What to record
- A watch that stops in a particular position, or restarts when tapped, may be butting.
- Inspect the escape-wheel teeth under magnification for bent tips.
Repeated restarting of a butting watch can damage pallet stones; have the escapement checked rather than shaking it.